Product ID:POLYURETHANE SLOW REDUCER, 1600-03
MSDS Date:09/28/1994
FSC:8010
NIIN:00N066435
MSDS Number: CBDPQ

CARDINAL INDUSTRIAL FINISHES

1329 POTRERO AVE
SOUTH EL MONTE, CA 91733
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 818-444-9274

Preparer: BOB SYPOWICZ

Cage: 65860

CARDINAL INDUSTRIAL FINISHES

SOUTH EL MONTE, CA 91733 US

Telephone: 818-444-9274 OR 213-283-9335

Cage: 65860

5 @ 20C

CAS: 88230-35-7

Fraction By Weight: 40%

OSHA PEL N/K

ACGIH TLV: N/K

ACETIC ACID, BUTYL ESTER; (N-BUTYL ACETATE) (CERCLA).

CAS: 123-86-4

RTECS: AF7350000

Fraction By Weight: 60%

OSHA PEL 150 PPM

ACGIH TLV: 150 PPM/200 STEL

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

7.33

RTECS: 9999999VO

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYES:CAN CAUSE IRRITATION AND
REDNESS, TEARING OR BLURRED VISION. SKIN:MODERATE IRRITATION
POSSIBLE FROM PROLONGED EXPOSURE, DEFATTING AND DERMATITIS.
INHALATION:NASAL IRRITATION, HEADACHE, DIZZ INESS, NAUSEA, WEAKNESS
OR VOMITING. LOSS OF CONSCIOUSNESS. INGESTION: GASTROINTESTINAL
IRRITATION, (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:HEADACHE, DIZZINESS, NAUSEA, WEAKNESS.
WARNING, DETECTABLE AMTS OF CHEM KNOWN TO STATE OF CALIFORNIA TO
CAUSE CANCER AND/OR BIRTH DEFECTS/OTHER REPROD HARM MAY BE PRESENT
IN THIS PRODUCT.
Medical Cond Aggravated by Exposure:PRE-EXISTING RESPIRATORY
CONDITIONS, PRE-EXISTING SKIN DISORDERS, LIVER AND KIDNEY
DISORDERS.

First Aid:EYES:FLUSH W/WATER FOR @ LEAST 15 MINS. GET MED ATTN IMMED.
SKIN:WASH EXPOSED AREA W/SOAP & WATER. REMOVE CONTAMD CLTHG.
INHAL:REMOVE TO FRESH AIR. IF BRTHG IS DFCLT, ADMIN OXYG. IF BRTHG
HAS STOPPED, GIVE ARTF RESP. GET MED ATTN. INGEST:DO NOT INDUCE
VOMIT, KEEP PERSON WARM AND QUIET. GET MED ATTN.

Flash Point Method:TCC
Flash Point:72.0F,22.2C
Lower Limits:1.0%
Upper Limits:8.0%
Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE, WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA W/FULL FACEPIECE
OPERATED IN A PRESSURE DEMAND OR OTHER POSITIVE PRESSURE MODE.
Unusual Fire/Explosion Hazard:CNTNRS MAY DEFORM/EXPLODE WHEN EXPOSED TO
EXTREME HEAT. DECOMP PRODS MAY YIELD OXIDES OF CARBON & NITROGEN.

Spill Release Procedures:REFER TO SECTIONS FIRE & EXPLO RISK, HEALTH
HAZ DATA, REACTIVITY DATA, SPILL OR LEAK PROCEDURES & SAFE HANDLING
& USE INFORMATION.ELIM ALL IGNIT SOURCES, ABSORB LIQ IN ABSORBANT
MATL & PVNT SPREADING TO GROUND WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:PAINT AND SOLVENTS HAVE BEEN LINKED TO
LIVER ABNORMALITIES, KIDNEY AND LUNG DAMAGE.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTIED, SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUALS (VAPOR,
LIQUID, AND/OR SOLID), ALL HAZARD PRECAUTIONS IN THIS DATA SHEET
MUST BE OBSERVED.

Respiratory Protection:IF TLV OF PROD/ANY COMPONENT IS EXCEEDED,
NIOSH/MSHA JOINTLY APPRVD AIR SUPPLIED RESP IS ADVISED IN ABSENCE
OF ENVIR CONTROL. OSHA REGS ALSO PERMIT OTHER NIOSH/MSHA APPRVD
RESPS UNDER SPECIFIED CNDTNS . (SEE YOUR SFTY EQUIP
SUPPLIER)(SUPDAT)
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENT TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:CHEM & SOLV RESIST GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:SPLASH APRON. GB PROT HAND CREAM, IMPERVIOUS
CLTHG & CHEM RESIST BOOTS. ANSI APPRVD EMER EYE WASH & DELUGE
SHOWER.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING REST ROOM,
SMOKE IN SMOKING AREAS ONLY.
Supplemental Safety and Health
RESP PROT:ENGINEERING/ADMIN CONTROLS SHOULD BE IMPLEMENTED TO REDUCE
EXPOSURE.

Boiling Pt:B.P. Text:>260F,>127C
Vapor Pres:8.3
Vapor Density:HVR/AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NOT KNOWN
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:100

Stability Indicator/Materials to Avoid:YES
NONE.
Stability Condition to Avoid:EXTREME TEMPERATURES.
Hazardous Decomposition Products:DECOMPOSITION PRODUCTS MAY YIELD
OXIDES OF CARBON AND NITROGEN.

Waste Disposal Methods:DESTROY BY LIQUID INCIN I/A/W APPLIC REGS.
CONTAMD ABSORBANT SHOULD BE INCINERATED OR SENT TO AN APPROVED
LANDFILL IN ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.